1. Wait for about 1 minute to dry after stamping. 2. Close the lid of the stamp pad immediately after use to prevent the stamp being unusable from solidifying. 3. Only FLASH STAMP INK REFILLS can be applied into the pre-inked stamps. Other inks will damage the stamp.
After the ink in the pre-inked stamp runs out, you can infuse it with flash stamp ink refills for continue using. For different pre-inked stamps, there are many ways to refill:
METHOD 1
1. Add about 10 drops of ink slowly into the cartridge. 2. Wait for 1 hour. Then you can directly use it.
METHOD 2
1. Put the stamp on the table and open the top cap of the stamp. 2. Add about 15 drops of flash stamp ink into the hole, put back and close the cap. Wait for a while, and then you can use it.
METHOD 3
1. Drop some ink on the stamp pad and rub in evenly. 2. Wait it for 3 minutes to absorb the ink. 3. Wipe off the excessive ink with a paper towel. 4. Stamp on the paper repeatedly until the impression is clear.
